Bottom Feeders - Super 1.8 Weight Hangers for Axial® SCX24™

The Bottom Feeders super weight hangers are a class 3 must and provide incredible weighting and tuning control corner to corner. They are intended to be used with our RidgeBeast 1.8" wheels.

• Adjustable canting forward or back
• Removable weight slugs. Each hanger also has 6 slots so you can mix and match weights to get your optimal weight balance and positioning. 
• Bearing supported two-piece nylon construction locks into the axle's knuckle

Axle Compatibility: The initial version is designed to fit our X15 axles front or rear. MEUS ISO version to come in the near future.

Wheel Compatibility: They are designed to only work with super 1.8" wheels such as our RidgeBeast wheels. The hangers rely upon either our +6 or +7.5 MF6 Hubs to properly support the hangers via the bearing. We welcome wheel designers to design around our adjustable hubs to provide further options. Please reach out via email if you're interested.

Weights:

• Bare Hanger w/ Bearings and Nylon Hub: 11.5g
• Aluminum: 0.5g Each (6- 3.1g)
• Brass: 1.9 g each (6- 11.2g)
• Stainless Steel: 1.8g Each (6- 10.5g)
• Tungsten: 3.1g Each (6- 18.7g)

Use our calculator below to help guide you to the best setup for your needs.

Includes:

• 2x Nylon Hangers
• 2x Nylon Axle Attachment
• 4x +7.5 Nylon MF6 Hubs
  • 2x include lip for rear axle applications
• 12x 8mm x 6mm Keel Weights in material of choice
• 4x 20mm x 15mm x 4mm Bearings
• Hardware

Important Install Info

• Included Nylon +7.5mm MF6 Hubs (No lip) Steering axle only
• Included Nylon +7.5mm MF6 Hubs (With Lip) Rear straight axle only
• When using with our metal MF6 hubs on the rear, you will used the included M2 countersunk screws to prevent the hangers from sliding too far inward over the axle.