Mofo RC | Replacement +6mm Lower Link Set (For Axial® SCX30™) - Made In Texas

These are replacement +6mm lower links for our Piranha and Cyber Snake chassis kits. They will not work on a stock chassis without a custom upper link mount and are only intended for those that did not get the chassis kit with the extended links included. You can simply use any stock-sized upper link.

Weight:

• Titanium- 4.2g
• Brass- 6.8g

Includes

• 2 Front Lower Links
• 2 +6mm Rear Lower Links
• O-rings
• Note: Requires stock link balls/ball studs

Install: When installing these onto a Cyber Snake or Piranha chassis, you must use the +6mm Link Riser insert (Short). Remove the front stock link and ball studs. The small link balls will need to be removed from the skid plate side.  BE VERY CAREFUL. These are extremely small. It’s easiest to grab both sides with needle nose pliers and carefully push the plastic off.  Install this side and then move to the axle side. The links are intentionally a tight fit so take your time.  Install the axle side by removing the shock bottom and the ball stud if needed.  It it easier to start with the axle side on the rear so you don’t have to unscrew the ball stud. 

Notes:

• An o-ring can be added on one side to remove the minimal play you may experience in the links or to gain extra clearances with some shock positions. It isn't necessary given the small size, but may be helpful to some.
  
• Brass naturally tarnishes over time. They can easily be cleaned or polished for those looking for an updated appearance.