The RockWolf is a compact 32-bit brushless/brushed mini crawler ESC built on the AM32 platform. Measuring just 27mm × 17mm × 8mm and weighing 5g, it delivers smooth low-speed control and quiet operation with PC tuning capability. This is a great budget-friendly option for our brushed motors, NanoBAM, NanoBeast, and SMP motors. For the absolute best low speed control on all our motors, easier tuning via phone, and an adjustable BEC, check out our Reaper 30A ESCape 32 ESC.
Features:
AM32 Based
Dual-mode operation: pre-programmed brushless or brushed (selectable at checkout)
20A continuous / 25A burst current
2S–4S LiPo
Built-in 7.5V/3A BEC for servo power
Conformal coating for water resistance
Sinusoidal startup for smooth throttle response
Included USB Type-C programmer for field configuration via PC
Dimension: 27mm x 17mm x 8mm
Weight: 5g
Setup & Configuration: Your ESC ships pre-programmed in your selected mode with low-voltage cutoff set to 3.3V per cell. Use the included programmer and the Multi Config Tool (emailed after fulfillment) to adjust motor parameters, frequency, and protection settings. For brushless motors, input pole count and KV; for brushed motors, connect the 2-wire connector to the black and yellow pins on the 3-port connector. Note: USB-C cable required for programming (not included).
Warranty: 90 days
Setup:
FOR BRUSHED MOTORS- THE 2 WIRE MOTOR CONNECTOR WILL PLUG INTO THE BLACK AND YELLOW PINS OF THE 3 PORT CONNECTOR ON THE ESC
Once you download the Multi config tool open the .zip folder, Uncompress it and the program you need to run it is called Serialportconnector, Click the box that says Direct connect, And directly below that select the port that show up you are connected to. Click connect then click M1 at the top to connect and settings will appear.
"I really like this ESC, super small, super easy to setup as long as you have a PC, and super smooth operation. I like the ability to program it for better performance. The ONLY thing I wish is if it worked with the Escape32 firmware so I don’t have to borrow my friends PC to reprogram it. I have a Mac, so it’s not so easy."
— Bielzebub (4/5)
"Pretty good esc for the price , most definitely looking to purchasing another one in the future."
— Paul (5/5)
"awsome"
— dexter (5/5)
"Was good until i finally built a rig and put it into it the motor works but the steering does not"
— Jaden (1/5)
"Easy to set up"
— Ethan (5/5)
"Super smooth when paired with his motor and servo. Liquid smooth"
— Austin (5/5)
"Works great"
— Paul (5/5)
"Excellent product"
— Randy (5/5)
"This esc rocks. Total equivalent to competition"
— Randy (5/5)
"So far its fine"
— Kevin (4/5)
Q&A
Choosing a selection results in a full page refresh.
